I like to know how to make the UNO send a lightintencity value from de ADC A0 to the ESP8266 over WiFi to a phone with P2P wifi connection each 1ms. After loading Blink to the ardunio UNO the WiFi dit not work on the Serial monitor nor on the wifi html page. I have had a working led on/ led of html page and UNO, but I do not know how It happend and why. Is this the right sequence: ? press and hold flash button (On) then press the reset button (On) Release the Restet button (Off) wait for the Arduino to program over USBasp and to finish the programming and verification. You must upload code while the TX led is lit. I do not understand step 5 of the flashing : Press the RST button while holding down the FLASH button on the breadboard - you should see a blue light on the Wi-Fi module and the TX led on the Arduino will light up. In order to be able to change it and make it behave the way I like. Hello I am new to WiFi and UNO and I like to know how things work. The FLASH button connects the GPIO0 pin on the Wi-Fi module to ground. Note: the RST button connects the RST pin on the Wi-Fi module to ground. If the serial monitor is printing "." repeatedly, you have entered your WiFi information incorrectly. If the flash fails try the above steps again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |